Notifications
Clear all
Topic starter
I have a CP4 with a stereo volume pedal & a Neo Mini Vent. I have the keyboard output to the volume/ out the pedal to the Vent/ out the Vent to the amp. When I split the keyboard with ie. bass on left & organ on right, I can't figure out how to stop the Vent effect on the left/bass side. Any help? Thanks
Posted : 15/02/2018 7:39 pm
The Neo Mini Vent is mono in, stereo out, right? So you're just running one CP4 channel to the Vent (via the pedal)? What are you doing with the other CP4 channel? Is your amp setup mono or stereo?
Posted : 16/02/2018 8:30 pm
Topic starter
Yes. You're correct. Mono in, stereo out on the mini vent. Only using 1 output on the keyboard & yes KC series amp has 2 inputs per channel/
Posted : 16/02/2018 10:42 pm
Topic starter
Can the mini vent be used as a foot controller? I had a FC7 hooked up to control the onboard rotary effect & got rid of the effect on the botoom.
Posted : 16/02/2018 10:59 pm
Well, with that setup you could run the other CP4 channel to the other channel of the stereo pedal, from there directly to the amp. Then you'd have two routes to the amp, one through the Vent, the other direct. Then create a Performance on the CP4 where you hard-pan the voices, Main (organ) voice hard-panned to whichever channel goes to the Vent, Split (bass) voice hard-panned to the other channel, bypassing the Vent.
EDIT > PART > PLAY MODE > PAN (Main voice all the way one direction, Split voice all the way the other direction).
Or you could use a small mixer and hook the Vent into the FX loop, and dial in what you do or don't want to send to the Vent.
Posted : 16/02/2018 11:30 pm
Topic starter
Thanks for the help. I'll try it & sounds like it should work.
Posted : 16/02/2018 11:36 pm
