Synth Forum

Notifications
Clear all

Sound is not correct?

3 Posts
2 Users
0 Reactions
1,387 Views
 Han
Posts: 0
New Member
Topic starter
 

I last got my Montage and having loads of fun.

I was playing with FM EP & Strings and if I sellect it i hear the FM Piano but not the strings. If i change the faders still i dont hear it but if I audition it then there are strings.

If i look at the 4 parts, 3 of them get the signal from the keyboard but the strings not. Only if i sellect that part and get tot the shuttlewheel then I see the input appear and the sound of the strings is there.

If I the change a sound and the back to the FM EP & Strings again the stringsound is gone.

Anyone got the same problem? and how can I correct it?

Regards Han

 
Posted : 21/12/2017 3:17 pm
 Jean
Posts: 0
Eminent Member
 

Hi

The Ribbon control the elemts level of part 4 and It is in Hold mode.

If you don't like this behavior, edit the elements level , delete this controller and adjust volume of part 4 with his slider.

 
Posted : 21/12/2017 3:50 pm
 Han
Posts: 0
New Member
Topic starter
 

Just found out myself that the Ribbon controls that Element. But thxs for answer Jean. I will change it because I think its strange to use a Ribbon for volume control.

 
Posted : 21/12/2017 6:37 pm
Share:

© 2024 Yamaha Corporation of America and Yamaha Corporation. All rights reserved.    Terms of Use | Privacy Policy | Contact Us