Synth Forum

Notifications
Clear all

Hi Folks: I am trying to configure my Motif Rack XS with a FW16E board. I previously was able to see the board in the control pannel under device manager but since I switched the MIDI to mLan and the driver to "FW", the board no longer shows up in the device manager. Has something happened to the FW16E board? Is there a hard reset I can try? I did execute the factory reset but, no joy. Would it help to reflash the firmware? Thanks all over the place gang.

33 Posts
2 Users
0 Reactions
7,612 Views
 Jim
Posts: 0
New Member
Topic starter
 

Hello Bad Mister:

There is no sound when I hot wire the XS and neither does it appear in the Sound Video and Game Controlers section. I do, however, get the same result: when the "Yamaha Steinberg FW Bus" is enabled, the computer is turned off, and the Rack XS is turned on, the "Yamaha Steinberg FW Bus" will not load when I boot the computer until I turn off the Rack XS. After turning off the XS, the "Yamaha Steinberg FW Bus" loads immediately.

Thanks.

 
Posted : 14/06/2015 9:33 pm
Bad Mister
Posts: 12303
 

when the "Yamaha Steinberg FW Bus" is enabled, the computer is turned off, and the Rack XS is turned on, the "Yamaha Steinberg FW Bus" will not load when I boot the computer until I turn off the Rack XS. After turning off the XS, the "Yamaha Steinberg FW Bus" loads immediately.

But this time there is no mystery connect sound when you power off the Rack XS... ?

I will inquire and see what I can find out, for you.

 
Posted : 14/06/2015 11:00 pm
 Jim
Posts: 0
New Member
Topic starter
 

Bad Mister:

"But this time there is no mystery connect sound when you power off the Rack XS... ?"

Yes, there is the standard connect sound.
Thanks.

 
Posted : 15/06/2015 8:25 pm
Page 3 / 3
Share:

© 2024 Yamaha Corporation of America and Yamaha Corporation. All rights reserved.    Terms of Use | Privacy Policy | Contact Us