Notifications
Clear all
Topic starter
Hi. I bought and installed a FL1024M flash board into my MoXF6. When I start the formatting process, it hangs on "Executing ...". I've let it run over 30 minutes ... and it still says "Executing ...". I'm running 1.11 firmware. Any thoughts?
Posted : 14/09/2016 10:59 am
Hi Paul,
the duration for the formatting process depends on the size of the installed flashboard (512M, 1G or 2G) AND on the amount of data currently stored on that board. If it is fully empty, formatting process will only take about 25 seconds. If it is fully loaded with waveforms, it CAN probably last longer than half an hour to proceed. However, DON'T EVER interrupt any ongoing read/write access to/from the flashboard (e.g. by turning the synth off), as you might damage your board.
Posted : 15/09/2016 10:54 am
Topic starter
Turns out my MoXF6 is faulty - the card I have worked in two other MoXF machines just fine.
Posted : 26/09/2016 10:56 am
