Synth Forum

Notifications
Clear all

MOXF6- how can i change octave for each part in performance mode

2 Posts
2 Users
0 Reactions
1,269 Views
 Duc
Posts: 0
New Member
Topic starter
 

like the title,i cant figure it out how to change the octave for each part
i want a string on part 1,part 2 another string start from C4 to the right-end.and with 1 higher octave,and part 3 is a cello from left side to C4
how can i do this? or MOXF6 dont have this feature?
sorry for my bad english

 
Posted : 26/03/2017 6:24 am
Bad Mister
Posts: 12303
 

In PERFORMANCE Mode:
Press [EDIT]
Press [1] to Select PART 1
Press [F1] VOICE
Press [SF1] VOICE

Here is where you select Voices for the four Parts of the Performance. Notice the other [F] and [SF] buttons under the screen let you select different settings for each Part.

Press [SF3] LIMITS
Here you can set Note Limit regions Low and High for each Part

Press [F4] TONE
Press [SF1] TUNE
Here you can Note Shift each Part up or down by semitones, as you may require. 12 semitones to an octave.

 
Posted : 26/03/2017 12:52 pm
Share:

© 2024 Yamaha Corporation of America and Yamaha Corporation. All rights reserved.    Terms of Use | Privacy Policy | Contact Us