Synth Forum

Notifications
Clear all

Reface DX has no signal through midi in out to NI Komplete 6 interface and also 2nd similar Reface midi issue

2 Posts
2 Users
0 Reactions
939 Views
 dirk
Posts: 0
New Member
Topic starter
 

PROBLEM #1 Reface DX connected to new Native Instruments Komplete Audio 6 MK2 via midi breakout and midi in/out cables. Reaper has NO signal from the Reface DX, though the mic and other keyboard connected via XLR on the the laptop, are coming into Reaper just fine.
DX breakout cable midi out is connected to Komplete 6 midi in, and Komplete 6 midi out is connected to Reface DX midi in on the breakout cable.
What could be the problem?

PROBLEM #2 I have a Crumar Mojo 61 with upper and lower keyboards. A fabulous instrument built in Italy by a coder. I have an MJU from Crumar which is an arduino device to power and allow the lower manual to act as a full midi controller keyboard. With the MJU midi in/outs connected to the Reface DX in/outs on the breakout cable I have NO sound from the Reface when it is supposed to be controlled by the Crumar keyboard.
Is this a midi issue with the Reface DX midi signal?

Thanks all

 
Posted : 07/10/2020 1:49 pm
Bad Mister
Posts: 12303
 

PROBLEM #1 Reface DX connected to new Native Instruments Komplete Audio 6 MK2 via midi breakout and midi in/out cables. Reaper has NO signal from the Reface DX, though the mic and other keyboard connected via XLR on the the laptop, are coming into Reaper just fine.
DX breakout cable midi out is connected to Komplete 6 midi in, and Komplete 6 midi out is connected to Reface DX midi in on the breakout cable.
What could be the problem?

No audio connection is mentioned. You cannot hear MIDI. What are the audio outputs of the reface connected to?
I don’t understand your setup. What mic? What other keyboard? No laptop has XLR ??? Very confusing to read...

 
Posted : 08/10/2020 1:57 am
Share:

© 2024 Yamaha Corporation of America and Yamaha Corporation. All rights reserved.    Terms of Use | Privacy Policy | Contact Us