Synth Forum

Notifications
Clear all

Montage 7 feet distance

12 Posts
4 Users
0 Likes
3,736 Views
Manuel
Posts: 0
Eminent Member
Topic starter
 

Hello, I would like to buy a Yamaha Montage 7 and I have a question: what's the distance between the left and the right feet?
Can anybody check it for me? Thank you!

 
Posted : 18/12/2016 10:05 am
Joel
 Joel
Posts: 0
Estimable Member
 

Hi
Dimensions
Width 1,244 mm (49")
Height 131 mm (5-3/16")
Depth 396 mm (15-9/16")
Weight 17 kg (37 lbs., 8 oz.)

 
Posted : 18/12/2016 11:29 am
Jason
Posts: 7889
Illustrious Member
 

Joel, those are outer dimensions. I was looking for my tape measure because the requested dimensions are from the center-line of the rubber "feet" along the width of the keyboard.

This would be 49" minus 2x the distance in from the edge of the keyboard to the center-line of each "foot".

I'm not aware that there's a mechanical drawing that documents the bottom-plate and foot locations, hence the need to break out the tape measure.

 
Posted : 18/12/2016 11:51 am
Peter
Posts: 0
Active Member
 

79cm between centres

 
Posted : 18/12/2016 11:18 pm
Manuel
Posts: 0
Eminent Member
Topic starter
 

Thank you very much!

 
Posted : 19/12/2016 7:47 am
Peter
Posts: 0
Active Member
 

Apologies Manuel, I have a Montage 6 which I measured and I guess the distance won't be the same for a Montage 7

 
Posted : 19/12/2016 11:58 am
Manuel
Posts: 0
Eminent Member
Topic starter
 

I see... can you measure the distance between the centre of one foot and the side of the keyboard, please? Maybe that distance is the same for every model.

 
Posted : 19/12/2016 12:37 pm
Peter
Posts: 0
Active Member
 

14cm
I'm surprised nobody who has a Montage 7 has measured theirs for you

 
Posted : 20/12/2016 2:12 pm
Manuel
Posts: 0
Eminent Member
Topic starter
 

Thank you again! 😉

 
Posted : 20/12/2016 6:05 pm
Jason
Posts: 7889
Illustrious Member
 

I couldn't find the tape measure. Keep in mind the Montage 7 has rubber feet in the middle of the keyboard as well. Not sure what you are trying to do and if the middle feet matter.

I measure (with a ruler - and there's error involved here) 47.2cm from the center foot to each outside foot. That would be closer to 94.5cm from left-most to right-most foot.

 
Posted : 21/12/2016 11:21 am
Manuel
Posts: 0
Eminent Member
Topic starter
 

Thank you for your help!

I have to put the Montage on a table stand that's 114,5 cm wide, so I need to know if the rubber feet will stay inside that lenght.

 
Posted : 21/12/2016 6:03 pm
Jason
Posts: 7889
Illustrious Member
 

No problem. For that application, you would care about the end-to-end of the feet (not centerline). The feet are much less than 10cm in diameter - and even adjusting for tolerance of my measurement - you should be fine landing all of the rubber feet completely within the width of the table.

 
Posted : 21/12/2016 9:16 pm
Share:

© 2024 Yamaha Corporation of America and Yamaha Corporation. All rights reserved.    Terms of Use | Privacy Policy | Contact Us