Synth Forum

Notifications
Clear all

Cracking Noise from right Output

2 Posts
2 Users
0 Reactions
1,967 Views
Posts: 0
Active Member
Topic starter
 

Hello!
I am using Yamaha MoXF6 which is directly connected to studio monitors using its L/R unbalanced outputs
The problem is there's a little cracking noise or distorted noise from the Right output

I tried changing the cables and also tried interchanging the monitors(L&R) and came to a conclusion that the cracking noise is only from the right output of the MoXF
The left output is completely fine

Plz note the cracking noise is only in the high mids and high frequency area(last two octaves of MoXF6)
I tried managing the gain and Q factor which does reduces the cracking a little bit

What should be the problem?
Is that a hardware problem?

 
Posted : 06/07/2020 4:55 pm
Bad Mister
Posts: 12303
 

You can further narrow the potential causes by plugging in a set of headphones to the MOXF - Since the same signal is duplicated at the Phones output, if you hear the cracking in the Phones it will tell us that the issue internal to the MOXF. If you do not hear the same cracking sound then the problem is likely a physical issue with the right analog output jack.

 
Posted : 06/07/2020 9:48 pm
Share:

© 2024 Yamaha Corporation of America and Yamaha Corporation. All rights reserved.    Terms of Use | Privacy Policy | Contact Us