Notifications
Clear all
MOXF Series Music Production Synthesizers
2
Posts
2
Users
0
Reactions
988
Views
Topic starter
I know you can save all the data on user memory to a flash drive. But what about JUST saving one song. Is that by choosing AllSong?? I am trying to free up memory, so is it better to save ALL data, or just the one song that you know is taking a LOT of memory? If you delete the song after that, how hard is it to "find" that song, is you saved ALL data, and then loaded ALL data. Wouldn't it be easier to just have that one song on a flash drive instead? Just wondering...... Thanks
Posted : 23/04/2020 11:09 am
Here’ s how it works. You can SAVE to USB stick ALL SONGS (.X6S) This will Save all Songs in the Song Mode sequencer including all the Mixing setups and Mix Voices. You have a choice when you go to LOAD from this File — you can Load “All Song” or just a single “Song”.
Once you have Saved an ALL SONG file you can erase (Clear) any Song or you can Clear them all... with your .X6S file you can Load them one by one. You will find that a single Song loads in about two or three seconds.
Because there are 64 Song locations you are not offered to SAVE just one at a time. It is SAVE all, LOAD one or LOAD all.
Important to know: Saving All Songs does not save the USER VOICES... It only saves the Mixing setup and any Mix Voices — those you have stored locally within the Song itself. Each Song can store 16 Mix Voices (256 for the entire instrument).
Posted : 23/04/2020 11:26 am
