Notifications
Clear all
MOXF Series Music Production Synthesizers
2
Posts
2
Users
0
Reactions
1,894
Views
Topic starter
While in performance mode triggering arps 1 thru 6 is an automatic process and this is timed to execute at the next measure. Lets say arp1 is triggered and you are playing along and then you decide to press SF2 to trigger arp2.
This time you want to activate the next arp, but instead, you want it to kick off the start sequence when you press your next note key, the note key press would start the arp and the arp would trigger at the next available measure in the performance.
Is there a setting for this?
Posted : 29/12/2018 6:32 pm
Sorry, each time I read it I’m not sure about what you are asking.
Typically once Arps start if they are set to Loop, they will continue forever or until they get a command to Stop. If you set one of SF button to recall an Arp set to “Type = Off” (Arp Type 000) then when that [SF] button is pressed the Arp will not play, it STOPS... touching a different [SF] button that contains an Arp Phrase will re-arm the Arpeggiator which will begin when you *next* touch a Key that meets the Note Limit and Velocity Limit to trigger that Arp.
Posted : 01/01/2019 4:30 pm
