Notifications
Clear all
Topic starter
I'm a proud new owner of an MX49. I'm trying to figure out how I set the Transmit channel? I see in a couple guides that discuss that you can change the Tx channel, but how? I reviewed the Utility / Midi section but nothing has a Tx channel option. Operational guide shows it exists but I can't find the option anywhere in the manual.
Please advise.. pretty import function for me to have access to.
thank you
Neil
Posted : 10/01/2018 5:00 am
You don’t say what your application is but you can have your MX49 Transmit Out via MIDI on any channel 1-16.
Press [PART SELECT]
Press a number button [1]-[16] corresponding to the Channel you wish to transmit on.
Local Control determines whether the internal tone generator will also respond.
Posted : 10/01/2018 12:50 pm
Topic starter
Hi! thanks for the info Bad Mister! I'll look to try your suggestion asap. My immediate need is just to have mx49 act as a controller Transmitting on channel 2 to another workstation (and use the local control volume to add other sounds at the same time).
I've upgraded from a controller keyboard to this and that was the functionality of the controller keyboard.
I'll post back after I try .. probably on the weekend. Thanks again!
Posted : 11/01/2018 4:22 am
Topic starter
That's it!.. Thank you for the prompt assistance Bad Mister. Looking through all the manuals, I don't think I would have found this at all as there is no terminology that by selecting a part is what will trigger /determine what the Tx channel is.. not the way my old school midi head interprets things from other synths I've used. But it's all good now.
thanks again!
Posted : 14/01/2018 2:48 am
