Hi
Dimensions
Width 1,244 mm (49")
Height 131 mm (5-3/16")
Depth 396 mm (15-9/16")
Weight 17 kg (37 lbs., 8 oz.)

Joel, those are outer dimensions. I was looking for my tape measure because the requested dimensions are from the center-line of the rubber "feet" along the width of the keyboard.

This would be 49" minus 2x the distance in from the edge of the keyboard to the center-line of each "foot".

I'm not aware that there's a mechanical drawing that documents the bottom-plate and foot locations, hence the need to break out the tape measure.

79cm between centres

Thank you very much!

Apologies Manuel, I have a Montage 6 which I measured and I guess the distance won't be the same for a Montage 7

I see... can you measure the distance between the centre of one foot and the side of the keyboard, please? Maybe that distance is the same for every model.

14cm
I'm surprised nobody who has a Montage 7 has measured theirs for you

Thank you again! 😉

I couldn't find the tape measure. Keep in mind the Montage 7 has rubber feet in the middle of the keyboard as well. Not sure what you are trying to do and if the middle feet matter.

I measure (with a ruler - and there's error involved here) 47.2cm from the center foot to each outside foot. That would be closer to 94.5cm from left-most to right-most foot.

Thank you for your help!

I have to put the Montage on a table stand that's 114,5 cm wide, so I need to know if the rubber feet will stay inside that lenght.

No problem. For that application, you would care about the end-to-end of the feet (not centerline). The feet are much less than 10cm in diameter - and even adjusting for tolerance of my measurement - you should be fine landing all of the rubber feet completely within the width of the table.