Here are some Performances i've been programming.References

I am familiar with the intermediate parameter linking a controller with an audible parameter, from my work on the Roland XP and XV synths. Why is t...

BadMister wrote: "Now when Part 1 is selected Assign Knob 1 will directly control Cutoff Frequency." Aha! So the knob's destination varies with wh...

Jason, thanks for the tip about always knowing if I'm thinking "Global" (common) or "Part". Hopefully quite helpful, I think, going forward for me. ...

PS: Bad Mister, I didn't just assume Knob 1 only went with Assignable 1 - For some (apparently other) reason, I could not get Part 2 to respond un...

Thanks, J, for simplifying things! 😉 😀 And thanks BadMister for the link. Especially interested in the FM angle. It's gonna be a Long Night! ...

...and BadMister, I am going to print this quote of yours and tape it over my bed: Link a Part AssignKnob to the SuperKnob Next link Part 1's Assi...

Thank you very much, Jason, and BadMister too. Jason, I think you saw more what needed clarification in my thinking, (although I signed in just now to...

When I try to set my MacPro as the clock Master (usually in Digital Performer) the Montage kind of 'steals' that position when I'm not on that screen,...

Great question, and great answer. Thanks, guys!:)

I think there's a consensus on this board that the numerical display of the Volume (in the Mixer window, for example) should reflect the net result of...

Thanks Jason! Will check out that link. And oops, cm, not mm, right.:) The 0.7% error is no doubt, also attributable to me - I wasn't sure whether to...

Ah, I see, and thanks Jason (and Rod) for helping me understand the issue better. Well here's an idea that might work - it's less Tesla and more moped...