Notifications
Clear all
MX Series Synthesizers
3
Posts
2
Users
0
Reactions
2,764
Views
Topic starter
Hi there! I've just purchased an used MX49 v1 (2012), everything works just fine except all the effects: reverb, chorus, tremolo, amp sim, wah, etc. Every patch that has at least one of those effects activated, it doesn't sound at all until I turn that effect OFF. And when I navigate through all the effects, sometimes it sounds a noisy CLICK sound between them. Can it be repaired?
Posted : 08/07/2019 10:28 pm
Topic starter
So I did a little research and I discovered how to make it run on "TEST" mode (pressing C#1, F1 and G#1 before powering on). I did the test on: ROM, RAM, WAVE ROM, Tone Generator, etc. everything was OK, except the EFFECT RAM and EFFECT RAM 2 which gave me "NG" (opposite of OK). So I suppose that my Effects RAM failed :'(
Posted : 11/07/2019 10:16 pm
Have you tried a factory reset? Under [UTILITY]/Job option 3 is Factory Reset. Try that first and if it still isn't working they you will need it serviced.
Posted : 18/07/2019 11:38 pm
