did you try: 44,1 kHz - 16 bit - Stereo?
Sladjan wrote: Personally, I'd rather see a waveform editor with the ability to create multisamples and save them in the Montage library format bec...
Eyal wrote: They're all there. but non of them are linked to any of the sounds. Yamaha decided not to bring in any of the Motif XF / MOXF per...
Andrea wrote: Thanks, I will try it. Do you know witch synth is used in the original track ? br /> In above live performance on 0:23 I recogni...
hypothesis . - an empty part sends the ZONE-information it contained the last time that this part was used (after starting up the Montage) - a part...
I found out that all parts can cause earlier mentioned problems (not only 9-16 but also parts 2-8). At my Montage V1.20 I noticed following: . When ...
Bad Mister wrote: Quick (basic) question: How many ZONEs do you have active. You know the limit is 8, right? Just saying... I have 3 - 8 zones...
BM thanks for your help and your earlier reply. Could you do following experiment: - Make a live set with 3 performances, test1, test2 and test3 ...
Are you sure it is sending the message? In other words if you change the program on the effect device to program 33, does it return to 100 or does it ...
My workflow is following I use one part for controlling an external device (f.e. part 8) go to PART SETTINGS -> ZONE SETTINGS -> note limit = G...
After some playing around I can 100% reproduce it now. It happens after I play certain performances, over and over again. I have to figure it out ...
I left the Montage untouched for about 3 hours and it didn't "freeze the MIDI program changes". It seems the problem is not time-related, I'll try it ...
Some experiments - Montage only sends these information via CH15. I checked all other channels, no unwanted data program change data send there - Ut...