I've used M-Audio EX-P pedals for quite a while with both Yamaha and Korg synths...they work OK and are small and lightweight (and inexpensive), but o...

I ran into another EG/time/speed issue when trying to make a mallet percussion attack faster at higher velocities: I thought that the EG's Time/Vel pa...

I think that I'd want limiting as the master effect, to apply to everything just before the output (and I'm pretty much using up the other effect slot...

A lot of info there, BadOne...I'm not trying to do anything here except be sure that peaks don't cause clipping / distortion in the signal chain downs...

My experience has been that modifying foot pedals sometimes works, sometimes doesn't...as mentioned above, there are so many variables, pot resistance...

JIm: Which Akai controller were you using? And I assume you were connecting it to the MODX with a standard MIDI cable, not a USB cable (?)... df

...so this suggestion can be passed on to the appropriate development / support people at Yamaha, and maybe we'll see it in some future upgrade (?)......

I know that you can used external hardware devices - I've used the (expensive) Kenton USB MIDI Host, and built a couple of far-less-expensive ones ($2...

Can the MODX be connected through USB to a MIDI controller (such as a wind or mallet controller) that has only a USB MIDI class-compliant device inter...

Earlier Yamaha synths were not USB MIDI class compliant, and class compliance is needed to support direct connection between instruments with USB...bu...

You could use a Kenton MIDI USB Host (see www.kenton.co.uk) to convert the EWI USB's USB Type-B output to standard 5-pin MIDI DIN, and then connect th...

Thanks, Bad One, I'm sure the Melas Waveform Editor can do the job (I use his MX tools, and they are very good) but I don't own an MOXF, a friend who ...