Thanks for putting these up so other people can see them easily, Jason...nothing complicated about that procedure for posting pictures here, eh?....on...
... if you're not a member of the other forum - you'll see: You do not have the required permissions to view the files attached to this post. .....
Most Korg keybeds (at least on high-end Korgs like the Kronos) can be removed as a unit, the metal structure or frame that supports the keys is what a...
Nobody on this forum has any information (that they can share here, anyway) about Yamaha's specific plans for future updates to the MODX...my take on ...
Peter - You're right, in time you get used to the way a different keyboard responds, and (subconsciously?) adjust your touch...I use both MODX7 and MO...
Thanks for the kind words, Blake...I did see that other guy's video on YouTube, and if Little Richard and Jerry Lee need to get their MODXs working be...
I notice that the sounds listed above with percussive attacks (drums, xylophone) have the lowest latency, and sounds that aren't typically perceived a...
You could try adjusting the Half Damper Time (on the Element/Amplitude editing page) to see if it gives you more of the half-damper feel that you want...
You can exchange parts within a performance, either from Performance/Home or /Mixing, by selecting a Part, then hold Shift and press Edit...this calls...
The M-Audio EX-P with my MODX has a MIDI CC data range of 0x00 to 0x7D when the minimum value control is set to the lowest (and reaches full range, 0x...
The OP agrees that while the FC7 is very nice, it is "a bit difficult for me to use, due to [its] rather large size"...again, the use of a more suitab...
I've used M-Audio EX-P pedals for quite a while with both Yamaha and Korg synths...they work OK and are small and lightweight (and inexpensive), but o...
I ran into another EG/time/speed issue when trying to make a mallet percussion attack faster at higher velocities: I thought that the EG's Time/Vel pa...
I think that I'd want limiting as the master effect, to apply to everything just before the output (and I'm pretty much using up the other effect slot...
A lot of info there, BadOne...I'm not trying to do anything here except be sure that peaks don't cause clipping / distortion in the signal chain downs...